Synthetic Enamel

Large Image
Thumbnail 1 Thumbnail 2 Thumbnail 1 Thumbnail 1

Synthetic Enamel

NEXEN Synthetic Enamel is an oil modified alkyd-based enamel paint. specially formulated for interior and exterior metal and wood surfaces giving them a touch of brilliance and breathing colorful life into your home. This high gloss paint will provide a lasting beauty even in harsh weather and helps to prevent fungus growth.

SURFACE PREPARATION

New Surfces
Wood

Wood must be dry and free from dirt, grease and other contaminants. Smoothen the surface with sandpaper. Clean off and dry.

Metal

Surface must be dry and free from dirt, grease and other contaminants. Ferrous substrate should be sanded or wire-brushed to remove mill scales and rust. Clean off and dry.

Previously Painted Surfaces
Wood & Metal

Any loose and flaking paint film must be scraped off. Defective areas should be sanded and smoothened. For ferrous substrates, rust should be removed thoroughly. The entire surface must finally be dry and free from dirt, grease and other containments. The scraped areas should be spot-primed prior to painting.

APPLICATION DATA

Drying Time:
- Touch Dry: 2 hours
(Depends on temperature and humidity)
- Hard Dry: Maximum 8 Hours - Recorting Interval: 16 hours
- Coverage: 13-15m2 per liter per coat
(May vary depending on the substrate conditions)
- No. of Coat 2-3
- For Optimum Results (Wood) Apply 1 coat of NEXEN Primer before applying NEXEN Gloss Finish
- For Optimum Results (Steel & Iron) Apply 1 coat of NEXEN Red Oxide Primer and 1 coat of NEXEN Synthetic Enamel
- For Optimum Results (Aluminium and Galvanized Iron) Apply 1 coat of NEXEN Primer, Undercoat before applying NEXEN Gloss Finish
Refer to Technical Data Sheet for Application and Thinning procedure.

DIRECTIONS FOR USE

  • Stir well before use.
  • Application can be done by brush, roller or spray.
  • Thin (by volume) up to 10-15% with White Spirit or Mineral Turpentine for brush or roller application, 15-20% for conventional air spray.
  • Clean up all equipment with White Spirit or Mineral Turpentine immediately after use.

SAFETY, HEALTH & ENVIRONMENTAL INFORMATION

RISK
  • Flammabel
  • Harmful by inhatation and if swallowed.
SAFETY
  • Keep out of reach of children.
  • Do not breathe vapor or sanding dust. Avoid contact with eyes and skin. When applying paint it is advisable to wear eye protection. In case of contact with eyes rinse immediately with planty of water and seek medical advice.
  • Wear protective clothing and mask while applying the paint. Use soap and water to clean the splashes from skin.
  • Keep container in a well ventilated place.
  • Care must be taken while transporting the paint. Always keep container in a secure upright position.
  • Keep away from food, drink and animal feeding stuff.
  • If swallowed, seek medical advice immediately.
  • Use sand to contain the spillage. Dispose off paint in accordance with the appropriate Environmental Quality Regulations.
  • Chemical Safety Data Sheet available on request.