Weather Guard

Large Image
Thumbnail 1 Thumbnail 2

Nexen Weather Guard

NEXEN Weather Guard is an acrylic emulsion paint specially formulated for exterior walls. It is extremely durable against harsh weather and adheres well to all types of exterior wall surfaces. NEXEN Weather Guard breakthrough formula provides tough resistance against dirt, algae, fungus, flaking and alkali.

SURFACE PREPARATION

Bare Masonry Surfaces Bare masonry surfaces should be completely dry and free from dust, dirt and grease. Use Bleach solution to treat the surface affected by fungus or algae. Repair cracks, uneven surface with NEXEN Putty or any suitable filler. Smoothen the putty / filler areas with sandpaper and dust off thoroughly. Allow all surfaces to dry completely prior to painting. Avoid painting when the moisture content and alkalinity of the wall is still high.

Previously Painted Surfaces Remove unstable paint film, loose chalk by rubbing down using abrasive paper or wire brush and dust off. Use NEXEN putty to repair cracks if necessary. Prime with NEXEN WALL SEALER.

Colour Range

As per our shade card and also available WHITE & BLACK

Pack Size

In 1.0 Liter quarter pack, 4.0 Liter gallon & 16.0 Liter drum.

Technical Data

- Film Thickness: Depending of method of application
- Wet: 50 Microns
- Dry: 20-25 Microns
- Drying Time: Touch Dry: Minimum 30 Minutes
- Hard Dry: 4-5 hour (Dependent on temperature and humidity)
- Recoating Interval: 4-5 hours
- Theoretical Coverage: 12-14m² per liter per coat. (May vary depending on the substrate conditions)

DIRECTIONS FOR USE

  • Stir well before use.
  • Application can be done by brush, roller or spray.
  • Thin (by volume) up to 30-50% with clean water for brush application, 30-40% for roller application & 40-50% for conventional air spray.
  • Clean up all equipment with water immediately after use.

SAFETY, HEALTH & ENVIRONMENTAL INFORMATION

  • Keep out of reach of children and away from food and drink.
  • Do not swallow the paint. If swallowed seek medical advice immediately.
  • Ensure good ventilation during application and drying.
  • Do not Breathe Vapor or sanding dust. Avoid contact with eyes and skin. When applying paint it is advisable to wear eye protection. In case of contact with eyes rinse immediately with plenty of water and seek medical advice.
  • Wear protective clothing and mask while applying the paint. Use soap and water to clean the splashes from skin.
  • Paint must always be stored in a cool and dry place.
  • Care must be taken while transportation the paint. Always keep container in a secure upright position.
  • Use sand to contain the spillage. Dispose of paint in accordance with the appropriate Environmental Quality Regulations. Do not discharge into drains or environment.
  • Does not contain any added Lead, Mercury, Chromium and Cadmium compounds.
  • Chemical Safety Data Sheet available on request.